An overview of my publications. Abstract, publication details and, where applicable, bonus material such as Gerber files are given.
Quadrature Bridge Measures Harmonic Distortion in Capacitors
This article considers the measurement of harmonic distortion in capacitors using a bridge circuit. Each arm of the bridge consist of one resistor and one capacitor. The bridge is driven in quadrature, such that both the differential and common-mode output voltage are nominally zero. The article introduces a procedure to construct a capacitor with very low distortion contribution, which is used in the reference arm of the bridge. The resolution of the bridge is estimated to exceed −150 dB. Measurement results for various capacitor types are presented. These show that parts with ceramic C0G dielectric have more consistent, and generally speaking also lower, distortion than Polyester, Polypropylene or Polystyrene film capacitors.
Linear Audio, Volume 12, September 2016
This article is co-authored by Scott Wurcer.
Reducing Transformerless Microphone Preamplifier Noise at Low Gain Settings
Contemporary high-quality condenser microphones offer noise performance close to the theoretical limit. Because large-diaphragm capsules and transformerless electronics have a high sensitivity, only modest gain from the preamplifier is required. Yet, designers of microphone preamplifiers have traditionally focused on the noise performance at highest gain, where the equivalent input noise (EIN) is at a minimum. At lower gain settings this figure worsens by an amount that depends on the detailed implementation, and may dominate the noise of the microphone. The EIN at highest gain is an insufficient and possibly even misleading criterion. The author presents a detailed noise analysis of the classic current-feedback instrumentation amplifier topology. The collector load resistors and the voltage noise of the operational amplifiers were identified as significant noise sources at low-gain settings. Connecting the collector load resistors to a higher supply rail is an effective technique for reducing the magnitude of the noise sources. Practical verification was found to be in excellent agreement with the predicted performance.
Journal of the Audio Engineering Society, Volume 63, Issue 3, March 2015
A Low Noise Laboratory-Grade Measurement Preamplifier
This article presents the design of a low noise laboratory preamplifier, which is particularly aimed at noise measurement tasks. Its design features a single-ended JFET input stage, an active drain load for good power supply rejection and a novel input AC coupling network which attains, together with a DC servo, a second-order response. The achieved performance includes an equivalent input voltage noise density of 390 pV/rtHz (1 kHz) and 500 pV/rtHz (10 Hz), a frequency response of ±0.1 dB (10 Hz–100 kHz), a power supply rejection of at least 95 dB (10 Hz–100 kHz) and a quiescent current of just 17 mA. Detailed theoretical background on low noise design along with concise construction and application notes are included.
Linear Audio, Volume 3, April 2012
Bonus material: a_low_noise_laboratory-grade_measurement_preamplifer.zip
A New Amplifier Topology With Push-Pull Transimpedance Stage
In this article I introduce an amplifier topology which uses a novel push-pull transimpedance stage. Compared to known standard amplifier configurations, the new circuit offers a substantial improvement in power supply rejection. Furthermore secondary slew rate limits are addressed, and sensitivity to loading from the output buffer is reduced. This makes this amplifier architecture particularly suitable for high quality audio power amplifier designs. Experimental results using model amplifiers are presented.
Linear Audio, Volume 2, August 2011
This article is also available online in the AudioDesign Line magazine of EETimes.